9. P20 projector Installation- Instructables

Ultimea
Ultimea

You can choose horizontal placement or hanger installation

Adjust the image projected on the screen

Check the horizontal and vertical settings of the screen

P20_projector_Installation-1.png

Ceiling installation

P20_projector_Installation-2.png

  1. Please purchase a universal projector ceiling mount;
  2. Remove the four rubber pads on the button of the projector, you will see the screw holes use the M6*11mm screws for installing the ceiling, and then install it. 

Adjust the projection mode by selecting Settings-Projection Setting-Front Desktop/Rear Desktop/Front Ceiling/Rear Ceiling

P20_projector_Installation-3.png

Note :

  1. During the installation process, please do not operate with electricity to avoid electric shock hazards and projector circuit failure. 
  2. Please keep a gap of at least 30 cm from the wall. Do not cover or block the projector's vents with any objects. Make sure that the projector has enough ventilation to ensure the projector's performance and reliability 
  3. Please make sure the projector is lower than the upper edge of the screen, otherwise it will affect the image effect. 

If you have additional questions, please do not hesitate to contactUltimea customer support at support@ultimea.com for further assistance.

Was this article helpful?

0 out of 0 found this helpful

Have more questions? Submit a request

Comments

0 comments

Please sign in to leave a comment.