Multiple Connection Methods for Poseidon M30 Soundbar 🔥🔥🔥🔥🔥

Recommend connection: ARC＞OPT＞BT>USB

Note: The Poseidon M30/Poseidon R3T does not have an AUX interface
Why is there no Aux interface?
Our design focuses on providing a higher-quality audio experience. HDMI and Optical fiber use pure digital transmission. Compared with the traditional AUX (analog) interface, they can provide purer and lossless sound quality and have stronger anti-interference ability. This is the mainstream way of modern high-quality audio transmission. If you need to connect old devices, it is recommended to choose an AUX to optical fiber or HDMI converter.

HDMI ARC Connection：

1. Check if the TV and soundbar are connected to the port that is marked "ARC" or"eARC" ("HDMI IN” does not support this).

2. Connect one end of the HDMI cable to the eARC/ARC port on the back of your TV.

3. Connect the other end to the HDMI (ARC) port on your soundbar.

4. TV Setting in detail:

A: Check if Dolby is turned off.

B: Check whether the PCM setting path is correct. 
Normally as below: Settings-Sound Output-Receiver HDMI (ARC) and

Sound -Expert Settings-Digital Audio Output -PCM

6. Check whether the cable is not connected wrongly or loosely

Note： If the connection and settings are correct, but there is no sound, please re-plug the HDMI cable or replace the HDMI cable 

Optical Connection:

Note: Remove the protective caps of the OPT cable.

Please note that the protective caps at both ends of the OPT cable need to be removed carefully. These caps are usually in place to protect the connectors during storage and transportation. Once you are ready to use the cable, make sure to remove the caps to ensure a proper connection. Failure to remove the caps may result in a faulty connection or no signal transmission at all.

1. Connect an optical audio cable from the TV's Optical Digital Audio Out port to the Optical in port on your soundbar.

2. Check if the sound bar switches to OPT mode.

3. Check whether the TV setting path is correct.

Normally as below: Settings-Sound Output-OPT and

Sound -Expert Settings-Digital Audio Output -PCM

4. Check if the optical cable other end has a red light on after connecting the TV port

if there is no red light, we suggest that to try a new optical cable. (the special material inside the optic cable, please do not bend the optic)

Bluetooth connection

1. Soundbar switches to BT mode via the remote control

2. Enter in TV -Sound Output-Bluetooth Speaker list to turn on Bluetooth and connect the soundbar device “Poseidon M30/Poseidon R3T” 

Bluetooth connection is successful when hearing "connected".

3. Press and hold the BT button for 3 seconds to disconnect the current device（BT flashing indicates waiting for pairing）

USB connection

The USB port is used to connect the USB flash drive(up to 64GB), it is unable to connect your devices with the USB cable directly.

Only supports USB format： FAT; FAT32

When you plug your USB flash drive with music in it, the soundbar will enter USB mode and play the music automatically.